SUSE 10下安装PHP MySQL Apache（英文）

SuSE 10自带装好的Apache不知道是哪里的问题
一直提示403出错，
GOOGLE一下，发觉这问题的人还真不少，
无奈之下，只好重装
有外国网友建议用Yast删除他，想想就算了，还是留着吧，最多不让他占用80口子

安装一个原则：多看手册

以下是PHP提供的，还不错
Example 2-4. Installation Instructions (Apache 2 Shared Module
Version)
1. gzip -d httpd-2_0_NN.tar.gz
2. tar xvf httpd-2_0_NN.tar
3. gunzip php-NN.tar.gz
4. tar -xvf php-NN.tar
5. cd httpd-2_0_NN
6. ./configure --enable-so
7. make
8. make install

Now you have Apache 2.0.NN available under /usr/local/apache2,
configured with loadable module support and the standard MPM prefork.
To test the installation use your normal procedure for starting
the Apache server, e.g.:
/usr/local/apache2/bin/apachectl start
and stop the server to go on with the configuration for PHP:
/usr/local/apache2/bin/apachectl stop.

9. cd ../php-NN

10. Now, configure your PHP. This is where you customize your PHP
with various options, like which extensions will be enabled. Do a
./configure --help for a list of available options. In our example
we'll do a simple configure with Apache 2 and MySQL support. Your
path to apxs may differ, in fact, the binary may even be named apxs2 on
your system.

./configure --with-apxs2=/usr/local/apache2/bin/apxs --with-mysql 注意这时，有时会报错：，因为SuSE上没装FLEX和bison赶紧去gnu去下，一路安装，绿灯，就OK了
/

11. make
12. make install

If you decide to change your configure options after installation,
you only need to repeat the last three steps. You only need to
restart apache for the new module to take effect. A recompile of
Apache is not needed.

Note that unless told otherwise, 'make install' will also install PEAR,
various PHP tools such as phpize, install the PHP CLI, and more.

13. Setup your php.ini

cp php.ini-dist /usr/local/lib/php.ini

You may edit your .ini file to set PHP options. If you prefer having
php.ini in another location, use --with-config-file-path=/some/path in
step 10.

If you instead choose php.ini-recommended, be certain to read the list
of changes within, as they affect how PHP behaves.

14. Edit your httpd.conf to load the PHP module. The path on the right hand
side of the LoadModule statement must point to the path of the PHP
module on your system. The make install from above may have already
added this for you, but be sure to check.

For PHP 4:

LoadModule php4_module libexec/libphp4.so

For PHP 5:

LoadModule php5_module libexec/libphp5.so

15. Tell Apache to parse certain extensions as PHP. For example,
let's have Apache parse the .php extension as PHP. You could
have any extension(s) parse as PHP by simply adding more, with
each separated by a space. We'll add .phtml to demonstrate.

AddType application/x-httpd-php .php .phtml

It's also common to setup the .phps extension to show highlighted PHP
source, this can be done with:

AddType application/x-httpd-php-source .phps

16. Use your normal procedure for starting the Apache server, e.g.:

/usr/local/apache2/bin/apachectl start

........